|
Who's Online
There currently are 6018 guests and 2 members online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This is a great manual. It was easy to read and very accurate. The size of the manual is small so email is no problem. I highly recommend it. The manual is very hard to find other than this website.
;
Manual was complete and available promptly, since I had lost my original manual. Very good response.
;
Whilst this is a photo copy, and some of the pages are a little askew, it was all readable and intact. A real bonus finding an old manual for a classic piece of kit that no other site had.
Great stuff.
;
excellent quality, contains circuits and scan quality, 110 pages
;
It was easy done, and I got exactly what I was looking for.
What to do If Something Goes Wrong
What to do If Something Goes Wrong
1. If the color balance is not right � If the color density leans to red or blue, or isn�t properly balanced, perform the color density adjustment, and the color balance adjustments for Yellow, Magenta, and Cyan. see page 92. 2. If the film you want to copy does not match the types of base film included. � If you do not plan on copying from this type of film often, use an unexposed frame of the same film strip, if available, when performing shading.
TRSR1A0E
� If you plan on copying from this type of film often, make a base slide using an unexposed, developed frame of the film.
1 2
1: Unexposed part 2: Mount
TRSR0S0E
� If you have no blank unexposed frame of the same type of film, you can use an unexposed frame from film produced by the same company, but the colors might differ a bit. 3. If the copy image is out of focus. � Check if the image on the film is focused or not. If it is, make sure the film is correctly set in the holder. � If you reset the film correctly in the holder and the image is still out of focus, or if you use a different image, and the copy image is out of focus in every case, please call your service representative. � You can adjust the focus manually with the focusing lever. see page 192. 4. If the edge of the original image does not appear on the copy. � Check the size of the area that can be copied. see page 176. � When setting film in the holder, be sure to position the desired frame properly. � To extend the area that can be copied, use the glass mount film holder and focus manually. 5. If the projection lamp does not light. � If the projection lamp does not light and a service message appears on the screen, the lamp might be burned out. In this case, please call you service representative. 6. If you move the mirror unit. � Perform the shading operation once again.
198
|
|
|
> |
|